-
The new base of the Elite series the holes if centered on the ram mount plate are not even on the plate. So if i were slide the lowrance mount either foward or backward the best i can do is two of the 4 holes to hit the ram mounting plate. The bolt pattern of the lowrance bracket is in a square, while everything else in the world is a rectangle.
Did that make sence? I will at work make an adapter plate, it was an inconvience that i did not anticipate.
-
Adapter plate sounds like the way to go. You're lucky you have the ability to make one at work. Plus... there's the whole manly feeling you'll have once it's done. You can tell everyone you MADE it work!!
It seems like I always have a "work in progress" in my shop. I just finished up a rod rack for my rig. I was going to build a bump board next, but then opted to go the way Red did and just pulled out the sharpie and a speed square! When they say "permenant" marker... they're not kidding.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Senior Member
Reply With Quote