-
I have had good luck helping this situation by making sure the legs of the clevis are perfectly straight. Usually they spread out wider where they fit the wire shaft. That does make a difference. The most common problem I now have comes from the bottom blade laying on top of the top blade. They just seem to lock each other up until you lift it out of the water. Hope this helps. Musky Glenn
Last edited by Musky Glenn; 01-04-2010 at 07:13 PM.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules